Translation and analysis of words by ChatGPT artificial intelligence
On this page you can get a detailed analysis of a word or phrase, produced by the best artificial intelligence technology to date:
- how the word is used
- frequency of use
- it is used more often in oral or written speech
- word translation options
- usage examples (several phrases with translation)
- etymology
fault tolerance - translation to russian
![clients]] without JavaScript support and/or incompatible browsers until December 2020.](https://commons.wikimedia.org/wiki/Special:FilePath/Twitter M2 mobile website.png?width=200 "clients]] without JavaScript support and/or incompatible browsers until December 2020.")
общая лексика
FT
отказоустойчивость
т.е. устойчивость системы и её способность восстанавливаться в случае отказа (нечувствительность к аппаратным сбоям), ошибок (обработка их без прерывания функционирования системы) или изменения режима функционирования. Отказоустойчивость - характеристика системы, обеспечивающей непрерывный доступ к данным, в отличие от систем класса high-availability (с почти непрерывным доступом к данным). Отказоустойчивость достигается в первую очередь схемотехническими решениями: дублированием основных узлов компьютера, введением горячего резервирования, возможностью замены блоков на ходу и т.п.
нефтегазовая промышленность
сохранение работоспособности системы при отказе отдельных элементов
['fɔ:lttɔl(ə)rəns]
нефтегазовая промышленность
отказоустойчивость
существительное
специальный термин
амортизация отказов
отказоустойчивость (возможность работы системы при отказе отдельных её элементов)
отказоустойчивость (возможность работы системы при отказе отдельных её элементов)
Definition
Wikipedia
Fault tolerance is the property that enables a system to continue operating properly in the event of the failure of one or more faults within some of its components. If its operating quality decreases at all, the decrease is proportional to the severity of the failure, as compared to a naively designed system, in which even a small failure can cause total breakdown. Fault tolerance is particularly sought after in high-availability, mission-critical, or even life-critical systems. The ability of maintaining functionality when portions of a system break down is referred to as graceful degradation.
A fault-tolerant design enables a system to continue its intended operation, possibly at a reduced level, rather than failing completely, when some part of the system fails. The term is most commonly used to describe computer systems designed to continue more or less fully operational with, perhaps, a reduction in throughput or an increase in response time in the event of some partial failure. That is, the system as a whole is not stopped due to problems either in the hardware or the software. An example in another field is a motor vehicle designed so it will continue to be drivable if one of the tires is punctured, or a structure that is able to retain its integrity in the presence of damage due to causes such as fatigue, corrosion, manufacturing flaws, or impact.
Within the scope of an individual system, fault tolerance can be achieved by anticipating exceptional conditions and building the system to cope with them, and, in general, aiming for self-stabilization so that the system converges towards an error-free state. However, if the consequences of a system failure are catastrophic, or the cost of making it sufficiently reliable is very high, a better solution may be to use some form of duplication. In any case, if the consequence of a system failure is so catastrophic, the system must be able to use reversion to fall back to a safe mode. This is similar to roll-back recovery but can be a human action if humans are present in the loop.
